|
|
|
Inspect Edge Finder before use by making contact between ball and body using paper clip or metal coin.
- Designed of one-piece construction which gives strength and accuracy.
- Made of high quality tool steel hardened to 60 RC
- Precision ground on all surfaces
- Four high visible lights
- Easily replace lamp and battery.
- Repeatability T.I.R within .0002" - 0.006 mm
|
|
- Do not place Edge Finder's body below work surface. Be sure that ball center is approximately 1/32" or 1 mm below work surface.
- Feed carefully towaed work piece. When a contact is made between ball and work piece, the lamp will illuminate.
- This Edge Finder is damage -free with spring-sustained ball. In case of over-travel, move backward and feed carefully. On touch the lamp will illuminate.
- At this position, half diameter of ball (.200") reads spindle center.
|
Designation |
Metric |
Inches |
| |
A |
B |
C |
A |
B |
C |
Edge Finder S20 |
20 - 0.006 |
93 |
10 |
.750 - .0002 |
3.66 |
.400 |
Edge FInder S32 |
32 - 0.006 |
138 |
10 |
1.250 - .0002 |
5.44 |
.400 |
|
|
